CO-Z Telescoping Flag Pole
Installation Instructions
Tools needed: Shovel, Spade or Post Hole
Digger, Tape Measure, Level, Container to mix concrete.
Materials needed: 180lbs of pre-mixed
concrete, water and 15-20lbs of Pea Gravel or Crushed Rock
Step
1: read instructions completely. Choose a location
for the flag pole where there are no obstructions, utilities or power lines beneath
the surface.
Step
2: dig a round “fence pole sized” hole, 12’’ in
diameter and 28’’ in depth. A larger hole maybe required for longer flag pole
or sandy and soft soil.
Step
3: shovel in 4’’-6’’ of gravel into the bottom of
the hole, which will provide water drainage.
Step 4: install the stop
bolt completely through the pre-drilled hole in the ground sleeve. Tighten it
by hand. Mix the concrete
Step 5: Push the sleeve
into the gravel and make sure that the ground sleeve is at least 1’’ above
ground level. If you fail to push the sleeve into the gravel, it will allow the
concrete to seal the hole and prevent water drainage.
Step 6: use the cap
provided to cover the ground sleeve. Begin to shovel the concrete into the hole
around the ground level sleeve being careful not to disturb the sleeve
position.
Step 7: remove the cap to
check the sleeve for plumb with a level in several locations. Install the cap
into the sleeve again to prevent objects from entering.
Step 8: wait at least for
24 hours before placing the flag pole into the hole.
How to Operate Your CO-Z Flag Pole Manual
Maintenance Tips
Your
CO-Z Telescoping Flagpole is virtually maintenance free! There are no
lubricants needed at any time during the life of the flagpole. You can easily
clean the exterior of your flagpole with liquid soap and water by using a car
wash mitt, or sponge. Rinse well, and wipe dry.
